Is it normal for the two MPPT outputs to have different power?
Is it normal for the two MPPT outputs to have different power?
Yes, it is normal. Differences in power can be caused by different orientations, obstructions, or angles of the photovoltaic group, and the device will automatically optimize the maximum power point.
There are two scenarios: ① Only the host grid-connected AC port outputs, with a rated power of 3000W (13A, limited by the inverter's output capacity); ② Inverter output + AC coupled inverter output, the total rated power remains 3000W.
AC charging power (drawing from the home grid) = Battery charging power set in the App (not exceeding 3000W) + Off-grid socket output power. The total of the two shall not exceed 3680W.
It is divided into two scenarios: ① Only the off-grid AC port is coupled for input (with external PV micro-inverter), the rated input power is 3680W; ② AC grid connection + AC off-grid port input simultaneously, the total rated input power is ≤ 3000W ...
According to EU safety regulations, the SolarFlow 800 Pro 2 will stop supplying power to the grid during a power outage; However, you can use the off-grid outlet during power outage with max 1000W power.
This warranty is only available to customers who purchased from Zendure’s official websites, Zendure Amazon stores or any Zendure authorized retailers. Parties wishing to participate in the Warranty Program must abide by the procedures and ...
Smart CT Mode is a Cloud-base feature, so you need to keep the SolarFlow and the ‘sensor’ devices have stable Wi-Fi connections all the time. Smart CT Mode Introduce the function of Smart CT Mode and its advantages and disadvantages Smart CT Mode is ...
1. We recommend setting the discharge limit to 10% to prolong the lifespan of your device. 2. It is advised to set the action of the device to "Shutdown" after reaching the discharge limit. You can do this on the same page of the App. 3. In case of ...
1. Energy storage devices: Wired connection via Ethernet cable (RS485 protocol). Note: SolarFlow 2400 Pro/AC+ and SolarFlow 1600 Pro/AC+ do not support direct RS485 communication via the Ethernet port. They must be connected to the RS485 terminals on ...
1. First, close the main circuit breaker of the household distribution panel. 2. Then sequentially close the GRID IN breaker, inverter breaker, and AC OUT breaker inside the PowerHub 3P. After completion, close the compartment door and tighten the ...
When off-grid, it automatically isolates the downstream backup circuits from the public grid. The backup circuits are independently powered by the energy storage battery to ensure uninterrupted power supply.
It supports fast off-grid backup switching at the 20ms level. The prerequisite is that at least one SolarFlow 4000 Mix Pro/AC+ energy storage device is connected per phase
Rated at 63A×3. It only closes when the Zendure PowerHub 3P fails and shuts down, switching to bypass power supply to maintain household grid power. Closing it is strictly prohibited in grid-tie mode.